Taillight KitĬlassic Mustang taillights suck. Please contact us if you require a different bulb base configuration.1964-1966 Mustang Advanced Sequential L.E.D. This enables simple plug-n-play signal connections. This tail light kit is configured with 3156 / 3157 type bulb bases in the Brake light and Back Up light positions and a 1156 type bulb base in the Turn Signal light position. Many aftermarket kits can not make this claim. This eliminates the chance of water intrusion which can lead to condensation, fogging and corrosion within the tail light housings. In addition, the kits are specifically engineered to not compromise the waterproof sealing of the tail light housings. This provides the vehicle with the absolute brightest and most noticeable tail light function. The panels will often light up areas that the OEM lighting does not illuminate. Unlike many aftermarket LED panels, our panels are specifically designed to utilize all available lighting area available in the tail light lenses. Ignition must be On to provide sequential flashing.Įach CST kit is uniquely engineered for each application. This allows running illumination and warning flashers when the key is out of the ignition. The exclusive design also allows the tail light panel to perform running light, brake light and emergency flasher functions when the vehicle is not running. This eliminates unnecessary current draw on the battery that can lead to a dead battery over time. When ignition power is Off, the tail light panels do not draw any power from the vehicle. The selection is stored in memory within the onboard controller so every time vehicle is started, the same pattern is used. Selection is performed while panel is powered up so user can observe each pattern until the desired pattern is determined. Each press of the switch steps panel through each of the available patterns. If sequential lighting patterns are desired, then the attached pink wire must be wired to +12 volt ignition power.Ī pushbutton switch on the back or front of the light panel is used to select from any of the pre-programmed sequential patterns. The simple installation requires a quick mounting of the LED lighting panel to the tail light housing or lens, depending on application and plugging in the wired bulb plug(s) into the factory bulb socket(s). So if you are looking for one of the best kits on the market look at picking up one of the Easy Performance LED kits from NPD today! No needing to buy extra parts or components. This kit from NPD includes the proper flasher module to make installation as easy as possible. Vehicles originally equiped with a 3 prong OEM type turn signal flasher will likely function properly. For LED lighting to function properly, vehicles that have a 2 prong OEM type turn signal flasher, a Low Current Flasher Module must be installed in place of the traditional turn signal flasher module. The kit is designed to work with OEM tail light housing and lenses as well as aftermarket components. There is no separate sequential lighting control module to mount and wire up. In addition, the kit includes a self-contained microprocessor and circuitry to enable a multitude of sequential lighting patterns. This includes low level running light illumination, brake light illumination, turn signal illumination, emergency flash and back-up lighting where applicable. The kits replace all the functionality of the light bulbs they replace. These kits incorporate high efficiency LED lights that increase tail light brightness, reliability and longevity. The Classic Sequential Tail Light (CST) kits from Easy Performance are direct retrofit and replacement for incandescent light bulbs in Foxbody Mustang.

LED TAIL LIGHT CONVERSION KIT, SEQUENTIAL, INCL (12) LED PANELS, DESIGNED TO INCL TURN SIGNAL, BRAKE LIGHT, RUNNING LIGHT, BACK UP LIGHT AND EMERGENCY FLASHER FUNCTIONS, FLASHER INCLUDED, 11 SEQUENTIAL PATTERNS

Sequential taillight